MakerWorld
Other House Models
Ver Modelo
Kitchen Hood Extractor Magnetic Backdraft Damper
104
Descargas
60
Likes
35
Makes
DISCLAIMER: THIS COULD BE AGAINST YOUR JURISDICTION'S CODE DEPENDING WHERE YOU LIVE AND A POTENTIAL FIRE HAZARD, SO PLEASE MAKE SURE IT FITS YOUR USE CASE AND YOU ARE AWARE OF THE RISKS INVOLVED. I WOULD SUGGEST USING HIGH TEMPERATURE FILAMENT TO MINIMIZE THE RISKSA simple 120/125mm kitchen hood extractor backdraft damper, with optional magnets (standard 4x2mm) to ensure a tight seal of the flaps.No support needed as they are already modeled, just snap them off before installingThe pins are not included as they would not work if 3d printed, just use some small nails or similar hardware, then add a drop of superglue from the outside of the case to ensure they wont back out.The holes are 1.9mm so a piece of rigid filament might also work, ideally something stiff and slippery like CF nylon. Print in PETG, ABS , ASA or better, don't use PLA as it will creep and deform under load.
Flux también publica en
24 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!