Thingiverse
Kitchen Roll Holder
von Ghostrider2171
3
Downloads
1
Likes
0
Makes
A simple kitchen roll holder to be mounted horizontally under a cupboard. I screwed it in with 4 self-tapping screws I found in the shed.
I printed with 10% infill, but I feel something like 30 would be more suitable - it started to crack a little when I was screwing it in.
The middle part (file: beam) was printed with a brim and tree supports.
The end cap with the slot (required to be able to remove and replace the kitchen roll) was printed with tree supports. All three parts can be printed together - it will add a brim to all three parts though which works but is not necessary.
I printed with 10% infill, but I feel something like 30 would be more suitable - it started to crack a little when I was screwing it in.
The middle part (file: beam) was printed with a brim and tree supports.
The end cap with the slot (required to be able to remove and replace the kitchen roll) was printed with tree supports. All three parts can be printed together - it will add a brim to all three parts though which works but is not necessary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
