Thingiverse
Kitchen Sponge Drain Holder
von ebuster
20
Downloads
12
Likes
2
Makes
__Remixed to fit wide sink border__
You may need to scale model a bit to match your sponges sizes (I used 110% enlargement).
Don't forget to add supports, to avoid my mistake! Most likely you only need it for top "side", not for drainer.
You may need to scale model a bit to match your sponges sizes (I used 110% enlargement).
Don't forget to add supports, to avoid my mistake! Most likely you only need it for top "side", not for drainer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
