Thingiverse
Kitchen Sponge Strainer / Stand
di admica
11
Download
6
Likes
0
Makes
This is a Strainer/Stand for a kitchen sink sponge. Tilted at an angle, water drops coming out of the sponge will run back into the sink instead of sitting there stinking up the sponge!
Parametric design. Change any parameter you want in the model. You can view it completed, and then broken down flat so you can print it easily without issue. Straight from the scad file, here's everything you can customize:
// Combo is the whole model put together.
// Use just_feet() and flat() for printing.
// Full model put together, pretty, but not printer friendly
//combo();
// PRINT THESE TWO BELOW:
just_feet(); // easily printable
flat(); // easily printable
///////////////////////////////////////////////////////////////////
// parameters /////////////////////////////////////////////////////
///////////////////////////////////////////////////////////////////
$fn=96; // smoothness of corners, spikes, and feet
//base
length=115; // length in the x dimension
width=69;
Parametric design. Change any parameter you want in the model. You can view it completed, and then broken down flat so you can print it easily without issue. Straight from the scad file, here's everything you can customize:
// Combo is the whole model put together.
// Use just_feet() and flat() for printing.
// Full model put together, pretty, but not printer friendly
//combo();
// PRINT THESE TWO BELOW:
just_feet(); // easily printable
flat(); // easily printable
///////////////////////////////////////////////////////////////////
// parameters /////////////////////////////////////////////////////
///////////////////////////////////////////////////////////////////
$fn=96; // smoothness of corners, spikes, and feet
//base
length=115; // length in the x dimension
width=69;
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!