Thingiverse
KitchenAid Hand Blender Mount
von Department_Nine
14
Downloads
25
Likes
1
Makes
Simple wall mount for KitchenAid® cordless variable speed hand blender KHBBV.
Needs two screws to hold inside cupboard or to wall; use pan or flat heads, never use countersunk heads with plastic. Make sure the screw head does not touch the blender. Designed to keep sharp edges away from the handle to stop it marking.
The contact area on the bed is not massive, so make sure your first layer game is reasonably on point. You may want to add supports inside the screw holes, I don't bother and the result is great. Run a file over the rear mounting surface to remove any bumps. Use a strong material that can cope with the relatively heavy blender and keep it out of direct sunlight.
Check out more designs from
Department_Nine.
KitchenAid is a registered trademark of Whirlpool Corporation.
Needs two screws to hold inside cupboard or to wall; use pan or flat heads, never use countersunk heads with plastic. Make sure the screw head does not touch the blender. Designed to keep sharp edges away from the handle to stop it marking.
The contact area on the bed is not massive, so make sure your first layer game is reasonably on point. You may want to add supports inside the screw holes, I don't bother and the result is great. Run a file over the rear mounting surface to remove any bumps. Use a strong material that can cope with the relatively heavy blender and keep it out of direct sunlight.
Check out more designs from
Department_Nine.
KitchenAid is a registered trademark of Whirlpool Corporation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!