Kite Dihedral

Kite Dihedral
An angle caused by 2 planes to create a wing
The angle of the dihedral is set for optimum stability for a kite
Using spars made from carbon fiber, fiberglass or wooden dowels the kite skin can be attached
Files for the following spar sizes have been produced:

5.5mm vertical spar with a 5.5mm wing spar
5.5mm vertical spar with a 4mm wing spar
5.5mm vertical spar with a 3mm wing spar

*7.5mm vertical spar with a 5.5mm wing spar
*7.5mm vertical spar with a 4.0mm wing spar
*7.5mm vertical spar with a 3mm wing spar

*7.5 to fit a sky-shark carbon spar

4mm vertical spar with a 4mm wing spar
4mm vertical spar with a 3mm wing spar

3mm vertical spar with a 3mm wing spar

All holes are a tight fit on the spars and drilling or reaming out might be required
I found 1.08 % to be the best in the slicer program (cura)
However your results might vary.

To make large fittings the % can be increased in the slicer program