Thingiverse
Kite string clip
door arpruss
55
Downloads
27
Likes
0
Makes
This is a simple clip for attaching a kite string to a kite. You can tie the kite string to this, and then switch the clip between kites.
I recommend printing in ABS at 100% infill. No supports needed. You may need to sand a bit to fit your kite's string hole.
Not flight tested yet.
Uses and includes my [Bezier library](http://www.thingiverse.com/thing:2207518).
The kite string holder that I'm using is [this one](http://www.thingiverse.com/thing:789726).
Update: Simplified model.
I recommend printing in ABS at 100% infill. No supports needed. You may need to sand a bit to fit your kite's string hole.
Not flight tested yet.
Uses and includes my [Bezier library](http://www.thingiverse.com/thing:2207518).
The kite string holder that I'm using is [this one](http://www.thingiverse.com/thing:789726).
Update: Simplified model.
arpruss publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
