Thingiverse
Kiteboard Wall Hanger
von maxme
36
Downloads
36
Likes
0
Makes
This is a simple design of a kiteboard wall hanger. I use it in my garage to store my board after rincing it.
Printed on an Ender 3, 0.28mm height, 20% filling.
I printed a smaller version (80%) it works fine.
Printed on an Ender 3, 0.28mm height, 20% filling.
I printed a smaller version (80%) it works fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
