Kitty Cat Headband

 Print Instructions:  I used .2 with 10%infill. All orientations should be correct and prints great without supports or raft. Print 1 Headband, 1 Cat All(has head and both paws)and 3 Plates. Sand and paint the parts as needed/wanted. Check that the plates slide in easy. if too tight sand a little if a too loose use a small piece of painters tape on bottom of plate. Plates are made to slide in and out but can be glued in if needed at the end. Then super glue the head and arms to the top of the plates. Once dry, slide the plates into the head band and hit the town. I printed in black so just had to paint the paws and eyes but thats up to you. I used painters tape and or rubber bands to hold plate while glue was drying. Easy print and simple build. I also have a flower add on which can be glued to the plates to make a flower headband.  WARNING: Check orientation of the plates with the orientation of the head and paws before you glue. The plates are made to slide in one direction so make sure you the direction is correct for the paws before gluing.