MakerWorld
Gadgets
Go to Model
Kiwi-1 Pod Holder
12
Downloads
3
Likes
6
Makes
This is a VapePod box, for my Kiwi-1. It can hold up to six Pods which can be held in place by small magnets. The Top of the box is also connected via two small magnets, however you would most likely not need it since it had a really nice fit on my print anyways. The magnets I used have 3mm in diameter and 1mm in height.Be aware while putting them in place, it's really hard to get them out again. You can find the magnets here: https://www.amazon.de/dp/B0D95R3P6M?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
