Klipperscreen ender 3 retractable console

Stock Ender3 screen was bothering me. Not so much because of the screen itself. but because of how it stuck out. Went with a RPi compatible screen to run klipperscreen,
Mine is a 800x480 5'' unit from DFrobot -> model DFR0550
Wanted to have it coupled with the printer and not sticking out, minimizing footprint.
designed this little console that is doublehinged. and very practical actually.
BoM:
2 - M5 nuts
1 - M5x45 (for the vertical hinge)
1 - M5x16 (for the horizontal hinge)
2 - M3x5 (outer side of screen, screws directly on the side flanges of the backpanel)
2 - M3x12 (inner side of screen, screws direclty on the side flanges of the backpanel)
1 - Pen spring between the yellow and red parts for tension

Instructions:
1 - Insert M5 nut on the housing on the hinge (yellow part);
2 - Attach coupler (red part) to the hinge with the smaller M5 bolt (don't forget the spring) and calibrate the tension;
3 - Install back and front panels on the screen and bolt the small