Thingiverse
KN95-case
door NikDFish
4
Downloads
1
Likes
0
Makes
This is a small case for one KN95 flat mask, folded, with magentic closure & sized for shirt pocket use.
Two copies of the same .STL are printed and joined by a piece of 1.75mm - 2mm wire acting as a hinge pin. 6mmx3mm magnets should be glued into the corners & oriented so as to attract the opposite.
Material choice is not important and no supports are required.
Two copies of the same .STL are printed and joined by a piece of 1.75mm - 2mm wire acting as a hinge pin. 6mmx3mm magnets should be glued into the corners & oriented so as to attract the opposite.
Material choice is not important and no supports are required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
