Knife Handle

After favourite kitchen knife handle gave up, wanted to give it a second life.

After much searching I found a thing of the style I liked (thanks pbarrios for thing:2790208) and remixed it to suit my blade.

Was a very quick and dirty mix in TinkerCAD, relocated the hole further from the blade and lengthen the length of the channeller the blade.

After printing really badly as it didn't properly adhere to the printer bed and thus curled :( I sealed it up with a 3d pen and sanded it smooth-ish.

If I was to print this again I would make the bald channel a little deeper, and do a better job of the sealing of the gaps between the two pieces, and try harder to find screws that I don't have to chop down to fit.