Knife sharpening holder - Simpler

Disclaimer: Be extra careful around sharp objects, do use this sharpener at **your own risk**!

Compared to all other sharpening jigs, this one doesn't require much assembly requires fewer parts, the whole stand is one piece. The sharpening stone holder requires a wooden dowel or carbon fiber rod (square or round).

And it can hold sharpening stones like these:
https://www.banggood.com/6Pcs-180--400--800--1500--2000--3000--Oil-Stone-Edge-Sharpener-Stone-p-954029.html?rmmds=detail-left-hotproducts&cur_warehouse=CN

The end holder uses 2 shorter M3 screws to "pinch" the holder against the rod and then one longer M3 can press the sharpening stone into the corner of the holder. Depending if the holes are populated with threaded bras inserts they either are for squeezing, or pushing.

The stand and holders do not have much adjustability, so measure your table thickness and print the correct thickness, small differences can be adjusted of the print by adding felt or rubber feet in