Thingiverse
knob for 1/4" bolt
door marmil
58
Downloads
38
Likes
1
Makes
Knobs for 1/4" bolts! Diameter of pictured knob is about 40mm (~1.5 inches).
Once printed you will need to drill out the small hole the bolt goes through with a 1/4" drill bit as it's modeled a bit undersized. I do this on purpose and then always drill the hole out so it's super clean/round.
You can put either a 1/4" bolt or a 1/4" nut into the knob depending on your project design.
Tip: Epoxy the bolt (or nut) in place if the knob will be regularly completely unscrewed so you don't loose your bolt (or nut).
Once printed you will need to drill out the small hole the bolt goes through with a 1/4" drill bit as it's modeled a bit undersized. I do this on purpose and then always drill the hole out so it's super clean/round.
You can put either a 1/4" bolt or a 1/4" nut into the knob depending on your project design.
Tip: Epoxy the bolt (or nut) in place if the knob will be regularly completely unscrewed so you don't loose your bolt (or nut).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!