Thingiverse
Knock Out Block
von jimwooly
4
Downloads
1
Likes
0
Makes
Used to knock out the nib and feed from sections of a fountain pen for cleaning or repair.
Print at 75% infill.
I made mine using PETG but I would think PLA would be ok also.
After printing the 'Punch', I found it better if it was cut in half to give 2 punches.
Print at 75% infill.
I made mine using PETG but I would think PLA would be ok also.
After printing the 'Punch', I found it better if it was cut in half to give 2 punches.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!