Thingiverse
Household
Ver Modelo
Knot a Vase
496
Descargas
477
Likes
1
Makes
Despite what you might think, this is “Knot a Vase.”
See here for stable download: https://thangs.com/mythangs/file/28152
The lattice structures are between 1.8mm – 2.0mm in diameter, so stick with a small nozzle. The model above was printed using a 0.4mm nozzle.
The pre-supported file has custom supports for the steepest sections, but with a structure like this it is inevitable that you will get small areas of print fail within the lattice. Best to clean this up with a small file afterwards than try to support every overhang.
See here for stable download: https://thangs.com/mythangs/file/28152
The lattice structures are between 1.8mm – 2.0mm in diameter, so stick with a small nozzle. The model above was printed using a 0.4mm nozzle.
The pre-supported file has custom supports for the steepest sections, but with a structure like this it is inevitable that you will get small areas of print fail within the lattice. Best to clean this up with a small file afterwards than try to support every overhang.
DaveMakesStuff también publica en
7 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
