Thingiverse
Knurled Pot
von fusionlab_3d
6
Downloads
3
Likes
0
Makes
What is this?!
Just your average storage pot. **Except KNURLED!**
That's right - this bad boy has precise knurling for when you need absolute grip and control when tightening (or loosening) the lid on this thing.
At 100% size this is 80mm diameter and 50mm tall, the inside height of the lower half is about 28mm and lid is 22mm.
Print Quality
Pictures shown are draft mode 0.25mm from Prusa Mini+ using Amazon Eono Silk Silver PLA filament.
Took about 5 hours total to print both parts and they came out much better than I was expecting - the thread tolerance is great (if maybe a smidge too tight, maybe need to adjust by 0.005 on next version).
Notes / Self evaluating feedback
It has quite a deep lid which reduces the functional capacity slightly, something I may make more shallow if I decide to tweak in future. However the proportions as they are look pretty.
If I were to be picky, another criticism may be that the knurl pattern doesn't perfectly line up when the li
Just your average storage pot. **Except KNURLED!**
That's right - this bad boy has precise knurling for when you need absolute grip and control when tightening (or loosening) the lid on this thing.
At 100% size this is 80mm diameter and 50mm tall, the inside height of the lower half is about 28mm and lid is 22mm.
Print Quality
Pictures shown are draft mode 0.25mm from Prusa Mini+ using Amazon Eono Silk Silver PLA filament.
Took about 5 hours total to print both parts and they came out much better than I was expecting - the thread tolerance is great (if maybe a smidge too tight, maybe need to adjust by 0.005 on next version).
Notes / Self evaluating feedback
It has quite a deep lid which reduces the functional capacity slightly, something I may make more shallow if I decide to tweak in future. However the proportions as they are look pretty.
If I were to be picky, another criticism may be that the knurl pattern doesn't perfectly line up when the li
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
