Kobra 3 Combo-Camera Bracket

Kobra 3 Combo-Camera Installation Guide 1.Tools: Camera Phillips screwdriver 2. Installation Steps: Step 1: Turn off the printer Before installation, turn off the printer and disconnect the power to ensure safe operation. Step 2: Print the camera bracket The camera needs to be mounted on the bracket. You can either print the model below or design your own bracket model. Step 3: Install the camera 1. Remove the camera cover and install the camera. 2. Connect the camera cable and install the rear cover of the bracket. 3. Assemble the camera bracket. Step 4: Install the camera bracket Install the camera bracket on the X axis, align it with the screw hole, and tighten the screw securing the bracket using a Phillips screwdriver（M3x8 self-tapping screw） Step 5: Connect the camera cable Connect the camera to the USB port of the printer. Note: There are two USB ports on the printer, and the camera can only be connected to the left port. 3. Check the installation effect: After the printer is powered on, if the camera icon is displayed in the upper right corner of the page, the printer is successfully installed. If the above steps do not provide assistance or if you encounter any other issues during subsequent use, we recommend that you create a support ticket.  The after-sales engineers will assist you in finding a solution to the problem(Reply time :1 working day) Please click this link to submit your ticket:  https://support.anycubic.com/VisitorTicket/guest?id=3&token=6e6e6f9affeKpTBnN5emV0ejsfQEYJUwFSUwNRAFMGTkAY