Kobra 3 Printhead ( Front piece)

I attempted making the Anycubic Kobra 3 printhead using AutoDesk Inventor The model is not perfect but it seems work hope you guys like it the support is kinda tough to take off i recommend using cutter or metal scraper to peel it off Recommendation layerheight 0.2 Support normal ;on build plate only print with the logo faced down Instruction Carefully take out the components take out the fan unscrewing two of the scew the led part can be taken out with flat head screw driver by pushing the right side of the circuit board and slowy shove it up put the component in the printed printhead make sure to align the wire through the bracket on the left side ****Dont forget to print at least 2 of the supportthingy.stl it need to be attach to the top portion of the model as seen in the picture as red part. *****as tested it will be tight fit if u slide it in Coloring the logo part of the stl can be colored using fill. if you point the cursor near the logo part you will see the outline or else just fill the entire part with the setting edge detection off and you will see the logo Notice Do this at your own risk Related models Cat ears https://www.makeronline.com/model/Cat%20ears%20for%20Anycubic%20Kobra%203%20printhead/29299.html please dont steal mywork ;-;;;;