Kobra 3 Toolbox

Wanted a simple toolbox out of the way for my Kobra 3. This toolbox mounts under the bed (use PETG or Easy ABS for the outside as PLA will likely warp due to heat, I used Easy ABS (Sunlu) and just white pla for the drawer. I don't use an insert in the drawer but I cobbled one together for those that might want one. To mount this, remove the hex screw in the case under the build plate on the left side, slide the toolbox up in there and just snug the screw so you can still wiggle the toolbox. Mount the left side mount that goes underneath the left side of the printer and you're going to pull slightly forward on that mount to snap the three pegs into the holes in the toolbox. This will create tension. Once that's done and it's exactly lined up with the left side of the printer snug down the screw in the plate. Pull forward on the left mount until the three pegs snap into the holes. Once you tighten the screw down after that step, it should not move.