Kobra 4 Gantry Lighting

Add lighting to your project on your Kobra 4 printer. This does NOT work with the Kobra X. Kobra X Version available here Uses standard 8mm COB and FCOB lighting. Here is a nice USB version here. Can be powered of the Kobra USB port or any USB wall adapter or computer. You will need a USB cable extension in whatever length you desire to get to your choice of power source. The USB cable routes nicely down the loom on right side. Requires four M3 x 30mm fasteners and four M3 nuts. The nuts are print in place so there will be a pause at layer 20 so you can drop in the nuts and then resume. The main bar is dovetailed in the center to join the sides. Add a drop of superglue if desired. There are two versions of this. Diffused and Non Diffused versions. The Diffused version spreads light more evenly but requires you to print with clear filament available here. The included models are set to two color printing so you can print in your color of choice and the diffusers section just where needed. As a bonus the lightbar mounts cover the ugly extrusions that come on the Kobra 4.