Kobra Max Direct Drive Mount

This is a remix of the Speed Drive direct mount to fit the Kobra Max. Everything fits well and doesn't flex unnecessarily.

This is designed to fit the stock stepper motor and extruder. I replaced with a pancake stepper to reduce weight.

To assemble:

1. Remove print head cover.
2. Disconnect fans, LED, heater, and thermistor connections.
3. Disconnect and unscrew circuit board.
4. Remove the two top v-slot wheels.
5. Press fit the 8 mm bearing spacer into the two large bottom holes on new mount.
6. Reassemble.
7. Push bowden tube all the way into hot end.
8. Measure how much of bowden tube to cut off before installing extruder.
9. Slide extruder bowden connector down onto bowden tube.
10. Place stepper motor into place.
11. Screw extruder into stepper motor.