Kobra S1 Vented Riser

Wanted a riser for a few reasons. First, didn't like the lack of support in the middle of the top plastic plate so this adds that. Second, I use a WyzeCam 2 to watch prints, and I wanted a mount that would allow that as I have on my other printers. Lastly, I don't like to keep the door open and a vented riser lets air flow / heat rise out without having to worry about breezes or drafts at plate level. This model requires minimal supports. I created the sides in two pieces, they will fit together, and I used a drop of superglue in each hole to hold them together though they are a snug fit. The only reason I created the sides that way is to eliminate print time (saved about 5 hours) and support requirements by printing them vertically. Note: This is intended to fit together very snug. The Wyze insert will *only* fit if put in perfectly straight. If you don't want to use a Wyzecam, or have another cam, should be easy enough to modify/create a mount that works. I've include