Kobra X Riser (Modular) with Storage

Kobra X Riser UPDATE: Mid section is up! It is an additional plate storage with 6 slots. It also adds another 40mm in height. The included dowels are to be glued together with the parts. Hello! I have decided to make a model to raise the printer with a storage space underneath. I came up with this simple modular design. Flush with the base of the printer and utilize all the space as much as possible while considering the structural integrity of the model. It adds about 10cm in height. The left side box can also be used as a poop bin, it does not cover the side vent on the left. I have tested mine and there was no wobble. Just make sure to calibrate after moving the printer. The model has been cut with dovetail joints to fit the bed plate. I designed it to be modular so I can add more storage space or plates in the future. UPGRADES I left some room for upgrades like a poop bin storage (which can be replaced with the left side drawer). I also added a notch at the bottom for if you want to add stock rubber or print a TPU feet. With the base riser done, there are more possibilities for other attachments to be made in the future. -05/18/26: I have added 2 options for the poop bin. One with a storage space under the machine and another with a full poop bin drawer. Feel free to choose what fits your preference. ASSEMBLY Assembly is straightforward, just connect the parts together. Gluing is highly recommended. No screws needed. FUTURE IMPROVEMENTS Please let me know if there are any suggestions for improvement or a specific design you want and I can redesign it. Feel free to optimize or increase walls for strength. PRINTING I set mine to be as strong as possible while using the least amount of filament (I tried) but feel free to optimize it to the best you can. Re-orient if possible I also added a modifier at the columns to compensate for the weight, Do not remove those. Thank you!