Kodama Trinus E3D v6 mod v1

There is no need to talk about the E3D v6, it is a state of the art reference hot end, you won´t get a better one.

What is the use of the mod, what are the differences compared to the trinus hot end:
- Even the E3D v6 has a PTFE inliner, it is a full metal hot end and at the time being only the trinus firmware limits its max temperature.
- No PTFE degradation, no changing extrusion problems over time
- No unstable extrusion/retraction problems, printing speed is only limited by trinus resonance problems and not by the hot/cold end extrusion capacity, I print PETG infill at 230 °C 0.2mm and 80-100 mm/s, before the mod I struggled to achieve 20 mm/s without problems, 80-100 mm/s will only make sense for some prints on such a small build volume, but it makes a huge difference if you print at e.g. 60-80 mm/s in average than compared to part "trinus_40mm_cold_end_fan_mount_E3D"

######################################################################
Maintenance position:
In ord