MakerWorld
Music
Model downloaden
Korg Volca Tri Stand
132
Downloads
54
Likes
73
Makes
I wanted a 3D printable Korg Volca stand that can hold 3 volcas specifically because I've seen a bunch of wooden ones, but hardly enough 3D printed ones with these kinds of angles. So I started making one from scratch using some of the angles the wooden ones typically use 15, 45, -15. I needed to break down the segments to fit them on the bed and I made a notch to prevent them from shifting, but it still needs hardware to hold it all together. I was just using some leftover 5mm screws laying around to attach the segments from top to bottom. But I still needed a threaded rod to cut down to size with some nuts to hold each side snuggly to the volcas so they don't move. I think it was ¼"-20 roughly 9.-9.5" in length. The cross supports that that providing backing and stability, two of them are basic, but the middle one I designed a cubby for my passive mixer. Pretty snug fit for my MyVolts MickXer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!