Thingiverse
Kossel Bed Leveling
door Yojimbojpr
66
Downloads
49
Likes
1
Makes
This is a bed leveling for Anycubic Kossel Plus, for a bed with 240mm diameter. I tried to minimized space for xploit all vertical interval.
Thread is M10x1, i tried M10x0.7 and is possible, but give some problems sometimes and doesnt present a clear advantage. And it is prepared for use DIN-7380 M4 screws.
There are two nut, lower is narrow for make more space and also have mark each 1/4 turn to have better leveling control, superior one is a little bit gross for better press
For a 240mm cristal bed Kossel you need to change reference points to; (-90,0,0), (45-78,0) and (45,78,0).
New version of base added, with less extrude length, 12mm are not necessary at all, I went down it to 8.
Thread is M10x1, i tried M10x0.7 and is possible, but give some problems sometimes and doesnt present a clear advantage. And it is prepared for use DIN-7380 M4 screws.
There are two nut, lower is narrow for make more space and also have mark each 1/4 turn to have better leveling control, superior one is a little bit gross for better press
For a 240mm cristal bed Kossel you need to change reference points to; (-90,0,0), (45-78,0) and (45,78,0).
New version of base added, with less extrude length, 12mm are not necessary at all, I went down it to 8.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
