Thingiverse
Kossel - Non-invasive Inductive probe mount
von ykatchou
24
Downloads
7
Likes
0
Makes
I want to have a proper bed leveling on my Kossel.
The issue I often had was the need to level before almost every print to have something properly ok.
The inductive probe is this one: https://www.amazon.fr/gp/product/B01EZZOP7Y/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 "LJ12A3-4-Z / BY 3 fils DC 6-36V PNP NO 4mm Commutateur de proximité inductifs Capteur"
It needed some resistance soldering in order to have the good voltage to trigger it.
It needed as well to "flash" your firmware (marlin, repetier or any other)
The issue I often had was the need to level before almost every print to have something properly ok.
The inductive probe is this one: https://www.amazon.fr/gp/product/B01EZZOP7Y/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 "LJ12A3-4-Z / BY 3 fils DC 6-36V PNP NO 4mm Commutateur de proximité inductifs Capteur"
It needed some resistance soldering in order to have the good voltage to trigger it.
It needed as well to "flash" your firmware (marlin, repetier or any other)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
