Kossel top mount spool holder

Most kossel kits don't come with a decent spool holder, your bed's never 100% level at the start and you need a decent spool holder that's easy to print.

The model's that this is remixed from use far too much plastic, bed volume and a printed bearing which can get noisy :) This is light weight, small & adjustable while also being able to fit almost any kossel I think!, yell out if you need extra length on the arms.

This design uses a old HDD bearing from a toshiba drive it has a 43 mm diameter on the bottom and 25mm on top.

The bungs included slot on top of the bearing, I've got 52mm and 54mm design's, I'm going to update the 52 one to save on plastic and add a label in the future. The bungs may need a slight sand depending on your Kossel's tolerances.

All part's were completely designed in Fusion 360

For best results
============

From my test's with the standard motor position of the extruder it has a tad bit of binding and you get a little bit of under extrusion w