Thingiverse
KPOS G2 Spacer
door SamK3D
1
Downloads
0
Likes
0
Makes
[01/05/2022] UPDATE: All files migrated to Printables: https://www.printables.com/model/186749
Spacer to take the wobble out of the rear trunnion. Nice tight lockup with any sized backstrap fitted. Tested with Gen 3 & 4 no problems.
Two models for G17 & G19, only differences is the width. Print on flat side, no supports necessary. Adjust Z axis in slicer if the fit isn't quite right.
High infill % as they can deform with use (but basically disposable so no problem), or just print sold (100%). PETG or ABS will work best.
If you liked a design, feel free to donate then unsubscribe.
https://www.patreon.com/SamK3D
Spacer to take the wobble out of the rear trunnion. Nice tight lockup with any sized backstrap fitted. Tested with Gen 3 & 4 no problems.
Two models for G17 & G19, only differences is the width. Print on flat side, no supports necessary. Adjust Z axis in slicer if the fit isn't quite right.
High infill % as they can deform with use (but basically disposable so no problem), or just print sold (100%). PETG or ABS will work best.
If you liked a design, feel free to donate then unsubscribe.
https://www.patreon.com/SamK3D
SamK3D publiceert ook op
21 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!