Krag Speedloader V1

Speedloader using primarily 3D printed components for a Norwegian Krag-Jorgenson. Works with Norwegian Krag-Jorgensons, and Ross Mk2 rifles.

Spring is a remix of the one in dragonofbattle's "Krag speedloader" I just adjusted it to fit in my design. Everything else was designed from the ground up.

Requires:
4x m3x12mm Screws
4x m3 Nuts
4x m3 Flat Washers

Notes:
All parts printed in PLA. Have not experimented with other materials.
Spring and latch should be 100% infill.
The spring and the follower should go into the body before the clamp bar is attached.
"Spoon (no feature).stl" is just a flat bar and is primarily intended for Ross Mk2 use, but is not necessary.
The Latch and Spring will eventually take a "set" after extended use or under load for long periods. Replace parts as necessary.
Do not store loaded, spring will take a set and cease function.
Untested with American Krags in 30-40, but 30-40 should sit comfortably in the body.
Not compatible with Danish Krags.