Kreg R3 Adjustable Jig

This jig is based off rocklobsters design https://www.thingiverse.com/thing:1621437 with a few modifications.

I designed it from scratch in Fusion 360 with a few tweaks to rocklobsters design to get the vice working without the arm falling out when winding it back and to also support the Kreg R3.
I also added in metric and imperial measurements as a guide for your R3 that match up with the ones that mount on the side of the device.

Parts list:
3x M10 nuts
1x 120mm M10 threaded rod
2x Washers
1x M3x25 or 30 mm screw
1x M3 Washer
1x M3 Wingnut
or if you use the locknut method
1x M4x25 or 30 mm screw
1x M4 Washer
1x M4 Wingnut
1x M4 Nylock
Aluminium for the vice face and to mount the jig too ( not shown in my pictures as i'm waiting on it to arrive )

To get the vice to work you will need to create a notch at one end of the rod as shown in the attached pictures - i used a lathe at work to do this but this can be done at home with a drill and a file - refer to http://w