MakerWorld
Sport & Outdoors
Ver Modelo
Kryptonite Lock Clip
16
Descargas
3
Likes
3
Makes
I was unhappy with the original mount system of my Kryptonite Mini-5 U-Slot. This replaces the aluminium slot on the shackle to insert the lock into its mount.The part is a first attempt to test for durability. I will report in a few month after using it daily.I managed to fit it with friction fit (after freezing the lock in the freezer).. I don't think this will ever move, even without the set screw! (unless it breaks!) I still plan to add the set screw with a heat insert later on, the hole is already there in the model.You may need to sand the hole to get it to fit perfectly. I had to install the part using a block of wood and a mallet.The result is a part much more snug than the original, which prevent the lock from moving and eventually loosen the mount over time. I just tried it on a ride, and now the bike is much more silent as the lock is not moving around anymore.Printed in PCTG in 0.4 with 6 walls Feedback most welcome.
v1ncen7 también publica en
60 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!