Thingiverse
Kubotan - printable
por Ryman
56
Descargas
46
Likes
0
Makes
An altered version of heileh's kubotan, made to be printable by most 3d printers without supports.
Original here:
http://www.thingiverse.com/thing:865700
Supports added in at the tip because it was still a sharp angle to print at, the flat side doesn't cut down on your ability to hold it much, I find.
I wanted it to be able to print while laying down length-wise because it seemed to me that standing it upright would make the layers more susceptible to being snapped apart.
Original here:
http://www.thingiverse.com/thing:865700
Supports added in at the tip because it was still a sharp angle to print at, the flat side doesn't cut down on your ability to hold it much, I find.
I wanted it to be able to print while laying down length-wise because it seemed to me that standing it upright would make the layers more susceptible to being snapped apart.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
