KVM Switch Underdesk Holder

I upgraded my desk setup with a new KVM switch that fully supports my setup of 3 PCs and 3 monitors. Naturally, I wanted to mount it under my desk, so only the remote would take up space on my desk top. So I created this holdeing bracket. It should be compatible with nearly all cheap 3PC 3 Monitor KVM switches with a similar formfactor. I tested it with those two products: https://www.amazon.de/dp/B0FCYKN5C5https://www.amazon.de/dp/B0FWB7G4JGIn addition, I notices that the display cables were hanging a bit downwards. So I designed a simple snap-on support bracket to hold up the cables on the connectors. This relieves some strain in the connectors in the cables and - most importanty - on the KVM switch box itself. There are two heights of the support snap-ons. I ended up using the smaller one. Make sure to let the print cool down enough so you do not bend it when removing from your build plate. If that happens, you need to use hot air to thermoform the bracket back.The bracket back has