Thingiverse
Kylo Ren Conversion
door weaver7237
1
Downloads
0
Likes
0
Makes
This is all the parts needed to convert a Disny Legacy Kylo Ren lightsaber to aftermarket soundboard, i.e. Proffie, GHv3, etc.
Sized to fit in a Halot R6 resin printer, but shoud fit almost all resin printers. Used ABS Like resin.
Remove all internals from saber hilt and replace with these. I mounted a single LED strip (2 pixels) for the chamber at the bottom.
For buttons, I cut out the existing buttons and left the holes, installed the button panel and mounted switches underneath.
I used standard battery connection tabs for 18650 battery in the battery bay. All wiring from upper to soundboard area runs under the battery bay.
Sized to fit in a Halot R6 resin printer, but shoud fit almost all resin printers. Used ABS Like resin.
Remove all internals from saber hilt and replace with these. I mounted a single LED strip (2 pixels) for the chamber at the bottom.
For buttons, I cut out the existing buttons and left the holes, installed the button panel and mounted switches underneath.
I used standard battery connection tabs for 18650 battery in the battery bay. All wiring from upper to soundboard area runs under the battery bay.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
