Thingiverse
Label for regal
door Toolix
0
Downloads
0
Likes
0
Makes
A label for a regal, mounted on a metal girder which holds the board.
On Github:
The label is designed for a regal girder with a height of 8 cm.
You have to print 2 parts, a top part and a bottom part.
You can print these without support.
Then you must assemble these 2 parts together.
You don't need any glue, both parts snap in.
You need 4 round magnets with size 10x1 mm.
Glue these on the back side into the holes.
You need a A4 paper.
Fold this paper twice an slide in by the slot in the side.
On Github:
The label is designed for a regal girder with a height of 8 cm.
You have to print 2 parts, a top part and a bottom part.
You can print these without support.
Then you must assemble these 2 parts together.
You don't need any glue, both parts snap in.
You need 4 round magnets with size 10x1 mm.
Glue these on the back side into the holes.
You need a A4 paper.
Fold this paper twice an slide in by the slot in the side.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
