Thingiverse
Lack Enclosure Camera Mount
di jchaager
198
Download
111
Likes
0
Makes
Built this suspended camera mount for my IKEA Lack enclosure. Wanted something that gave an overall view of the print bed while not getting in the way. Because the pin doesn't fix the hinge, the camera is free to swing out of the way when you reach into the enclosure as well as auto adjust itself if you adjust the camera.
The base of the camera mounts is screwed to the underside of the table above the printer. The arm is then attached using either 3mmx30mm screws, or in my case, a 3mm wire pin. The camera screws onto the arm by way of a 1/4"x20x1/2" screw.
The base of the camera mounts is screwed to the underside of the table above the printer. The arm is then attached using either 3mmx30mm screws, or in my case, a 3mm wire pin. The camera screws onto the arm by way of a 1/4"x20x1/2" screw.
jchaager pubblica anche su
4 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
