Thingiverse
Lack Enclosure Table Grommet
door littleab
8
Downloads
1
Likes
0
Makes
This is a cable grommet designed to fit the Ikea Lack table. I made this so that I could route cables through the bottom of the enclosure for the power supply as well as other things like power for the octoprint octopi. Both pieces can be printed together.
Drill a 1.25" hole through the table. Place the grommet through the drilled hole. Press the ring on the bottom to create a clean look to both the top and bottom of the grommet.
To insulate the hole with the wires in it, just press some foam into the grommet.
Drill a 1.25" hole through the table. Place the grommet through the drilled hole. Press the ring on the bottom to create a clean look to both the top and bottom of the grommet.
To insulate the hole with the wires in it, just press some foam into the grommet.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!