Thingiverse
LACK enclosure vent
von GromMaker
12
Downloads
7
Likes
0
Makes
A vent for an IKEA lack enclosure to allow warm air to vent out from the top. This will help to allow a basic temperature control to stop too much warm air building up inside, or to keep it closed to keep warm air in.
It uses a 64mm hole (as per the largest hole saw I happened to have).
Needs 1x M4 screw.
It uses a 64mm hole (as per the largest hole saw I happened to have).
Needs 1x M4 screw.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!