Lack Leg Drill Bit

## Lack Leg Drill Bit

This is a drill bit designed to make attaching and removing legs on lack tables quick and easy. The end of the leg fits securely into the face of the bit. The 1/2 inch shaft is recommended if your drill will accommodate, but the 3/8 inch shaft is provided for use with smaller drills.

- Print Recommendations:
- PETG or other high-strength material
- 100% infill, at least through shaft.
- Print on an edge with supports. Printing flat will dramatically reduce strength of the shaft.
- Recommendations for use
- Set your clutch appropriately to avoid over-torquing, which will break the shaft.
- Screwing down legs most of the way, then torquing down the last bit by hand will dramatically reduce the chances of breakage.