Lack Side Mount 608 Spool (Multi) Holder

I designed this based off my existing design but due to lack of space now that my enclosure is built, I need something that could hold more than 1 spool. This can be used as a single holder or 2-3. I dont recommend having too much weight on it as these tables are thin and could splinter or worse.

Most important factor is that my Vyper enclosure DOES NOT have plexi so this is an easy install and no glass modifications are needed.

The Block mounts on the left side of the middle table and has 3 screw holes to fasten it in place. Middle table is suggested for multi spool if running more than 1 printer as you can feed filament both directions (up and down).

The Left & Right arms slide into the Block via enlarged T-Slots. Use metal rods to secure ball bearings to arms.

End_Cap is only for each end to keep the 608 Ball Bearings in place. If you use the multi spool setup, use the Spacer for between the 2 open faces.


Single Spool Model List:

2x Block
1x Left
1x