Thingiverse
LACK table printer hinge/ latch
door Reciprocation_Props
133
Downloads
72
Likes
0
Makes
This is a latch/ hinge for converting a Ikea Lack table into a 3d printer enclosure, just print 3-4 of each part and install 2 as hinges and the other 1 or 2 as latches. There is a cut out on the back of one side meant for foamcore/ acrylic/ polybarbonate to be attached. The holes in the hinge plates are .125in across and the cut out is also .125in deep. It took about 5.5 hours to print all of the parts at .2mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!