Lack Table Raiser w/ Adjustable Height

A lack table leg raiser and takes an elevator bolt to allow for table leveling and rubber mount for reduced table vibration.

*Additional tools needed
Wood Glue (optional)
Dremel / Drill (optional)
4x Dowel Pin (1 inch long and 1/4 inch diameter) https://www.amazon.com/gp/product/B0055HPPSA/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1 (optional)
4x Elevator bolt (~1 inch length, and wider on the foot is better, 3/8 inch / 9.5mm width on bolt) (optional)
4x Nut (3/8 inch) (optional)
4x Rubber (I used a rubber washer as it was cheap and fit the elevator bolt nicely) (optional)

*To Install
Print leg. Glue rubber to bottom of elevator bolt.

Take a dowel peg and mark 1/2 down with a pen. Take Lack table leg and mark center position. Drill a hole that will tightly fit the peg 1/2 down. Put some wood glue on the peg and insert into the Lack table leg. Insert other side of dowel pin into the print. Take nut and screw onto elevator bolt. Place bolt and screw and place into p