Lack table Remix

I used Shoyun design and remixed it for my needs. I cutted the tabs that sandwich the plexiglass on the enclosure and replaced it with magnets and small piece of sheet metal. All sides can be removed, exepted the back, wich is made of 5/8'' plywood on hinges. I can mount the filament to the back, so it feeds easily. The LED are optionals but very practical. Fusion 360 likes to mess with scaling so use 2540% if the model is too big or too small. (1 inch = 25.4mm). The overall project was around 80 $CAD. Here is what I used :

*Magnets:
https://www.amazon.ca/gp/product/B01MZ6EJE2/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1

*LED strip:
https://www.amazon.ca/gp/product/B00HSF65MC/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1

*Lack table:
http://www.ikea.com/ca/en/catalog/products/20011413/

*Old hinges I had laying around

*Plexiglass from the home improvement store.

*12v Switch, wires, fork connector and zip ties.

*3/16'' thick foam trim to seal the side panels.

Tha