Lack Table Triple Stack With Magnetic Plexiglass / Lexan Holders

2018-04-29 : Updated the Bottom/Middle table adapter (Marked as v5). On my v2 print the screws I used on the bottom weren't recessed as much as I would have liked. I added a mm to the base thickness, and then recessed the hole by another mm. Im not going to re-print, but I thought I would add this for anyone who wants to ensure better recess. Ill leave v2 and v5 posted. You only need 4x of either version, not both!

2018-04-28 : Added middle table to bottom table bracket.


I wanted a stacked LACK table setup as well as magnets for the lexan / plexiglass.

I saw this Thing from jonthemiller: https://www.thingiverse.com/thing:2123893

Then I saw this Wanhao Lack Triple Stack Enclosure Attack Thing by OmNomNomagon. https://www.thingiverse.com/thing:2685750

My goal was to move the plexiglass closer to the outside edge of the Lack Table leg and use magnets in each corner on all four sides. The idea is to be able to remove any side of the enclosure plexiglass without too