Lack Table Underslung Spool Holder

Couldn't find anything like this, so modeled one up in F3D.

Hangs under your Ikea Lack table printer stand, Takes two skateboard bearings and an 8mm threaded rod.


I use it with these: https://www.thingiverse.com/thing:1998669 and a whole lot of locking nuts.

- The main bearing screws/glues/command adhesives to the edge of your table.
- The support bearing goes on the other end of the rod at least one spool-width away underneath the table, how you attach it isn't important, so long as it won't move as it presses against the bottom of the table.
- The 'bearing spacer' is there to make your main bearing a bit prettier as it protrudes 2mm from the housing.

You'll probably need to calibrate your printer's internal diameter measurements as I had a hell of a time getting housings I could actually fit bearings in.

I'm currently working on a printable filament duct, but it should also work with a 'reverse bowden' attachment.