Thingiverse
Laguna card reader fix position 2
por 3dsokol
0
Descargas
2
Likes
0
Makes
Created for Laguna card reader for the second button.
I did need to clip the plastic part a bit because it did not fit perfectly (where the screw goes to tighten the PCB).
Applied some strong glue and it fixed the issue of the card not being detected.
I also needed to cut the plastic housing which I could later not fit on the PCB. As I already glued everything together I could not repair it. SO PLEASE CHECK BEFORE GLUING.
For the first replacement fix I used and remix a part from @pberenyi - thanks you helped a lot.
org for postion fix 1:
https://www.thingiverse.com/thing:3466886
my remix:
https://www.thingiverse.com/thing:7105178
I did need to clip the plastic part a bit because it did not fit perfectly (where the screw goes to tighten the PCB).
Applied some strong glue and it fixed the issue of the card not being detected.
I also needed to cut the plastic housing which I could later not fit on the PCB. As I already glued everything together I could not repair it. SO PLEASE CHECK BEFORE GLUING.
For the first replacement fix I used and remix a part from @pberenyi - thanks you helped a lot.
org for postion fix 1:
https://www.thingiverse.com/thing:3466886
my remix:
https://www.thingiverse.com/thing:7105178
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
