Thingiverse
Lamp for 3D Printer
por pauloleal
13
Descargas
10
Likes
0
Makes
Lamp for 3D Printer, i used with my 3D geeetech A10M, glued on top of power supply
- A M3-.10 bolt & nut is required.
- 2-sided adhesive tape used on the base
- 4 3W RGB RGBW 8pin LED Diodos Blub parallel monted.
- Some 1,5mm wire
- 3,7v 18650 Bat.
- 4 resistors 470r
Enjoy
- A M3-.10 bolt & nut is required.
- 2-sided adhesive tape used on the base
- 4 3W RGB RGBW 8pin LED Diodos Blub parallel monted.
- Some 1,5mm wire
- 3,7v 18650 Bat.
- 4 resistors 470r
Enjoy
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!